All RideInn™ products are designed to last.

Cold bent heavy steel tubing and welded steel construction provides a product that will not “snap” apart from use.

The painted steel tubing is 0.880” in diameter with a wall thickness of 0.062” resists bending and abnormal wear anyplace any hardware is attached.

Special bush guided steel framed plastic caster wheels are used at every sliding vertical pole position. These reside within the slotted floor rails and are not subject to any impact.

“Ballistic Nylon” fabric is used to describe our woven polypropylene cloth covers. This woven cloth is also PVC coated on the inside rendering it fully waterproof.
All seams are double stitched and further reinforced inside by an interior sealing tape.

Ample use of Velcro™ tape stitched into the canvas will secure the cover to the retractable framework without fear of blowing off.

The RideInn™product is backed by outdoor tent and shelter manufacturing experience dating back to 1956.

Nylock™ style fasteners, washers acting as bearings, Nylon hold open straps, skirted cover at the base, two different locking methods and a host of installation anchoring methods are all details that add up to providing value to the product.

With its vertical post design with only an 18” span between centers, the RideInn™ excels in snow load capacity. In fact, the more weight is spread on, the better it resists collapse, we guarantee it!

Combine the 18” span of the heavy tubing, the fastening method of the cover, the wind resistance of the unit is such that it withstood the wind generated by being trailored BACKWARDS on a flat bed trailer for 1,500 miles at 70 MPH. This torture test was performed in temperatures that varied from sub-zero to 100 degrees in the sun.